Can i use GCD for background thread and performSelector for resume back to main thread? [duplicate] - ios

Question

I've used both GCD and performSelectorOnMainThread:waitUntilDone in my apps, and tend to think of them as interchangeable--that is, performSelectorOnMainThread:waitUntilDone is an Obj-C wrapper to the GCD C syntax. I've been thinking of these two commands as equivalent:
dispatch_sync(dispatch_get_main_queue(), ^{ [self doit:YES]; });
[self performSelectorOnMainThread:#selector(doit:) withObject:YES waitUntilDone:YES];
Am I incorrect? That is, is there a difference of the performSelector* commands versus the GCD ones? I've read a lot of documentation on them, but have yet to see a definitive answer.

Answer 1

As Jacob points out, while they may appear the same, they are different things. In fact, there's a significant difference in the way that they handle sending actions to the main thread if you're already running on the main thread.
I ran into this recently, where I had a common method that sometimes was run from something on the main thread, sometimes not. In order to protect certain UI updates, I had been using -performSelectorOnMainThread: for them with no problems.
When I switched over to using dispatch_sync on the main queue, the application would deadlock whenever this method was run on the main queue. Reading the documentation on dispatch_sync, we see:
Calling this function and targeting
the current queue results in deadlock.
where for -performSelectorOnMainThread: we see
wait
A Boolean that specifies whether the
current thread blocks until after the
specified selector is performed on the
receiver on the main thread. Specify
YES to block this thread; otherwise,
specify NO to have this method return
immediately.
If the current thread is also the main
thread, and you specify YES for this
parameter, the message is delivered
and processed immediately.
I still prefer the elegance of GCD, the better compile-time checking it provides, and its greater flexibility regarding arguments, etc., so I made this little helper function to prevent deadlocks:
void runOnMainQueueWithoutDeadlocking(void (^block)(void))
{
if ([NSThread isMainThread])
{
block();
}
else
{
dispatch_sync(dispatch_get_main_queue(), block);
}
}
Update: In response to Dave Dribin pointing out the caveats section ondispatch_get_current_queue(), I've changed to using [NSThread isMainThread] in the above code.
I then use
runOnMainQueueWithoutDeadlocking(^{
//Do stuff
});
to perform the actions I need to secure on the main thread, without worrying about what thread the original method was executed on.

Answer 2

performSelectorOnMainThread: does not use GCD to send messages to objects on the main thread.
Here's how the documentation says the method is implemented:
- (void) performSelectorOnMainThread:(SEL) selector withObject:(id) obj waitUntilDone:(BOOL) wait {
[[NSRunLoop mainRunLoop] performSelector:selector target:self withObject:obj order:1 modes: NSRunLoopCommonModes];
}
And on performSelector:target:withObject:order:modes:, the documentation states:
This method sets up a timer to perform the aSelector message on the current thread’s run loop at the start of the next run loop iteration. The timer is configured to run in the modes specified by the modes parameter. When the timer fires, the thread attempts to dequeue the message from the run loop and perform the selector. It succeeds if the run loop is running and in one of the specified modes; otherwise, the timer waits until the run loop is in one of those modes.

Answer 3

GCD's way is suppose to be more efficient and easier to handle and is only available in iOS4 onwards whereas performSelector is supported in the older and newer iOS.